do she run gooooooood!! Much improvement from before but it wasn't the air
flow screws alone that did it. The carb cleaner obviously loosened things up
inside and out to the point that the throttle response is as smooth as a
baby's....smile :-) Clean air filters and oiled up cables also made a
difference.
I am not through yet but I'll work on the rest of your suggestions this
week......if I can stay in town long enough. Thanks again Nick.
George the happy
----- Original Message -----
From: "nicholas.threader" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Sunday, April 22, 2001 12:07 PM
Subject: Re: Throttle body question
> Hi George , although you have set the air screws , you need to do all the
> things i recommended , at the same time , to reep the benefits of the
> changes made.
>
> The adaptors i used are brass with a 6mm thread one end and a spigot the
> other end , it has flats in the middle and a hole through the center (
just
> for your information ).
> I also fitted the adaptors with small 'O' rings , to seal the adaptors
> against the ports ( do not over tighten when fitting , hand tight will
do ).
>
> atb Nick T
>
>
> ---
> Outgoing mail is certified Virus Free.
> Checked by AVG anti-virus system (http://www.grisoft.com).
> Version: 6.0.250 / Virus Database: 123 - Release Date: 18/04/2001
>
