If they didn't REPLACE the valve cover gasket (mine didn't either the first time), they should have at least used an RTV silicone based sealant on the old one!
Kevin Hawkins // Greensboro, NC [EMAIL PROTECTED] http://www.kevinhawk.com Y2K Kawasaki ZRX1100 //'93 Yamaha GTS1000 //'85 FZ750 Bob, definitely no sign of any yamahabond... -----Original Message----- From: Bob J. [mailto:[EMAIL PROTECTED]] Sent: Tuesday, May 28, 2002 12:25 PM To: [EMAIL PROTECTED] Subject: Re: Dealer doldrums & valve clearances (longish) Joe; My experience has been that if they remove the cams and have to swap out some shims then it could run 300. A little high but not way out of line. 300 is high if they didnt have to pull the cams and if they havent done a GTS before it probably took them at least 1 hr to remove and replace the bodywork. I would wonder if they did actually take the valve cover off. Can you tell if there is any new yamahabond squished out around the gasket? Bob ====================================================================================== NOTICE - This communication may contain confidential and privileged information that is for the sole use of the intended recipient. Any viewing, copying or distribution of, or reliance on this message by unintended recipients is strictly prohibited. If you have received this message in error, please notify us immediately by replying to the message and deleting it from your computer. ==============================================================================
