Albs
who built it ???
thanks
Mick
Albs wrote:
> the guy who made my l20b head z24 block motor has been doing this
> conversion for a while with no real promlems (I surpose don't go overbored
> when you bore it out)
>
> >The 'other' Datsun list usually cites a casting fault in the Z24 block that
> >makes it undesirable - causes it to crack. Jason Gray in the US has a
> >website worth checking out if you're looking for a big cc L4 motor :
> >
> >http://home.att.net/~jason510/
> >
> >DF
> >
> >At 23:22 16/03/00 +1030, you wrote:
> >>the preffered approach to getting a 2.4 in your datto is to use the L20b
> >>block, Z24 crank, etc etc cos it is easier to register an L20b engine block
> >>than a big Z24 block.
> >>> my next dilemma is how to get a 2.4lL in my car without spending big
> >>> dollars on boring and stroking a L20B block and i know that u can put a
> >>> l20 head on a z24 block but i don't know the details involved in the
> >>> swap also is there down sides to this conversion because it is not very
> >>> common.
> >
> >
>
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.datascribe.com.au/ozdatonline/index.htm
http://www.datascribe.com.au/ozdatonline/listindex.html
---------------------------------------------------------------------
