john muscat (he's been mix & matching datto's for years)
>Albs
>who built it ???
>thanks
>Mick
>
>Albs wrote:
>
>> the guy who made my l20b head z24 block motor has been doing this
>> conversion for a while with no real promlems (I surpose don't go overbored
>> when you bore it out)
>>
>> >The 'other' Datsun list usually cites a casting fault in the Z24 block that
>> >makes it undesirable - causes it to crack. Jason Gray in the US has a
>> >website worth checking out if you're looking for a big cc L4 motor :
>> >
>> >http://home.att.net/~jason510/
>> >
>> >DF
>> >
>> >At 23:22 16/03/00 +1030, you wrote:
>> >>the preffered approach to getting a 2.4 in your datto is to use the L20b
>> >>block, Z24 crank, etc etc cos it is easier to register an L20b engine
>>block
>> >>than a big Z24 block.
>> >>> my next dilemma is how to get a 2.4lL in my car without spending big
>> >>> dollars on boring and stroking a L20B block and i know that u can put a
>> >>> l20 head on a z24 block but i don't know the details involved in the
>> >>> swap also is there down sides to this conversion because it is not very
>> >>> common.
>> >
>> >
>>
>
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.datascribe.com.au/ozdatonline/index.htm
http://www.datascribe.com.au/ozdatonline/listindex.html
---------------------------------------------------------------------
