So I've been building up my track 'toy'.  It has a V-mount setup for the
radiator and the intercooler.  I did this to allow cool air to both systems
at all times, as this car is being built for track use.

I'm finally ready to start debugging and setting the car up for autox
(testing) and then its new home on the track.  I hadn't finished my oil
cooler setup when doing all the fabrication and recent chats have got me
thinking about getting it finished sooner than later.

Oil cooler is an FD Rx7 oem unit.  It will use a Mocal Oil adapter with
thermostat.

My current plan is to place it parallel with the radiator, just under the
radiator fans.
front view of V:
http://i295.photobucket.com/albums/mm133/splitime/Miata%20build%20pictures/IMG_0490.jpg
side view
http://i295.photobucket.com/albums/mm133/splitime/Miata%20build%20pictures/IMG_0502.jpg
Here is a temporary bracket made to suspend the oil cooler during earlier
brainstorming... (this is the planned location)
http://i295.photobucket.com/albums/mm133/splitime/Miata%20build%20pictures/IMG_0521.jpg
http://i295.photobucket.com/albums/mm133/splitime/Miata%20build%20pictures/IMG_0522.jpg

Is that sufficient?
The IC/rad area is ducted on the sides and will be fully sealed off once I
finish the rest of the ducting.  All air into opening of bumper, will go
through radiator or intercooler.

I'm open to all thoughts ideas... ideally I want to use the current
cooler... since I have it... but please feel free to think outside the box.

I had also considered opening up the front bumper even more... hole saw in
the remaining area up front... across middle... and putting the oil cooler
right in the middle there. (now that I think about that one... I kinda like
it again... hurm....)
front bumper view, picture holes right below the bumper line:
http://i295.photobucket.com/albums/mm133/splitime/Miata%20build%20pictures/IMG_0130.jpg

-Dave
_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower

Reply via email to