I don't think you'll need it out front. Not if it's getting air flow  
in the mockup position.

I've got mine (tiny) mounted up in the nose with a small scoop (no  
direct air flow) and it's dropping temps 40f from no oil cooler at  
all. Peak temps after good 20 minutes of consecutive boosted runs  
showed a peak <230f. That's on a 2.0L engine with less than 5qts  
total capacity (with cooler). My lines and cooler probably add  
another 2/3rds quart.

Here's the current position:
http://i158.photobucket.com/albums/t86/m2cupcar/current%20FEmx5t/ 
baseshroud5.jpg

that works fine for street beatings, but my plans for track prep are  
going to be a Mercedes oil cooler next to my big rad a la  
"twincooler". That'll give me close to the same cooler capacity as  
the rx7 AND direct air flow from the mouth.

On May 12, 2008, at 2:00 PM, Dave Ott wrote:

> I do not have a target oil temp at this point (from my last oil  
> cooler setup on another car... i don't even remember my aims  
> then).  Mainly this is a desire to just not cook my oil and keep  
> everything running.  Heck, my entire v-mount system was built as  
> preventative maintenance.
>
> The "right behind the middle of bumper" idea is kind of leading me  
> now.  We still have to put in a tubular bumper bar... and I could  
> mount it off that.  It'll heat the air going to rad/ic some... but  
> i can't see it doing that much harm.

_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower

Reply via email to