I am sorry. My question was directed to Rob and the way his oil cooler is 
mounted in the mouth with the inlet and outlet at the bottom.
I must have deleted the wrong address from the reply-all selection.

________________________________________
From: Dave Ott [mailto:[EMAIL PROTECTED] 
Sent: Tuesday, 13 May, 2008 11:28
To: Murray, Richard; Miata Power List
Subject: Re: Oil cooler location (not the typical layout to work with)

The feed on the driver side is into the top of the radiator.  The bottom of the 
radiator is then run along that pipe on the passenger side to the back of the 
head.

-Dave
On Tue, May 13, 2008 at 10:24 AM, Murray, Richard <[EMAIL PROTECTED]> wrote:
Just out of curiosity; how did you bleed the air out of that setup, with both 
inlet and outlet at the bottom?

-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Rob Ebersol
Sent: Monday, 12 May, 2008 14:12
To: Dave Ott
Cc: Miata Power List
Subject: Re: Oil cooler location (not the typical layout to work with)


I don't think you'll need it out front. Not if it's getting air flow in the 
mockup position.

I've got mine (tiny) mounted up in the nose with a small scoop (no direct air 
flow) and it's dropping temps 40f from no oil cooler at all. Peak temps after 
good 20 minutes of consecutive boosted runs showed a peak <230f. That's on a 
2.0L engine with less than 5qts total capacity (with cooler). My lines and 
cooler probably add another 2/3rds quart.

Here's the current position:
http://i158.photobucket.com/albums/t86/m2cupcar/current%20FEmx5t/baseshroud5.jpg

that works fine for street beatings, but my plans for track prep are going to 
be a Mercedes oil cooler next to my big rad a la "twincooler". That'll give me 
close to the same cooler capacity as the rx7 AND direct air flow from the mouth.

On May 12, 2008, at 2:00 PM, Dave Ott wrote:

> I do not have a target oil temp at this point (from my last oil cooler
> setup on another car... i don't even remember my aims then).  Mainly
> this is a desire to just not cook my oil and keep everything running.
> Heck, my entire v-mount system was built as preventative maintenance.
>
> The "right behind the middle of bumper" idea is kind of leading me
> now.  We still have to put in a tubular bumper bar... and I could
> mount it off that.  It'll heat the air going to rad/ic some... but i
> can't see it doing that much harm.
_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower
_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower

_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower

Reply via email to