I'm going to say yes. Based on the fact that I know of more than one  
turbo Miata tracked for multiple seasons with only the stock oil  
cooler in place.

The one thing that rx oil cooler has going for it is capacity. I  
believe with lines and cooler you're going to get a full quart  
increase in your oiling system. That's HUGE. Then consider that at  
any moment you'll have about 3/4 quart sitting in the cooler. Will it  
receive air flow passed on from the radiator?

I'm also assuming you are aiming for oil temps around 220f on track...

rob


On May 12, 2008, at 1:07 PM, Dave Ott wrote:

> So I've been building up my track 'toy'.  It has a V-mount setup  
> for the radiator and the intercooler.  I did this to allow cool air  
> to both systems at all times, as this car is being built for track  
> use.
>
> I'm finally ready to start debugging and setting the car up for  
> autox (testing) and then its new home on the track.  I hadn't  
> finished my oil cooler setup when doing all the fabrication and  
> recent chats have got me thinking about getting it finished sooner  
> than later.
>
> Oil cooler is an FD Rx7 oem unit.  It will use a Mocal Oil adapter  
> with thermostat.
>
> My current plan is to place it parallel with the radiator, just  
> under the radiator fans.
> front view of V:
> http://i295.photobucket.com/albums/mm133/splitime/Miata%20build% 
> 20pictures/IMG_0490.jpg
> side view
> http://i295.photobucket.com/albums/mm133/splitime/Miata%20build% 
> 20pictures/IMG_0502.jpg
> Here is a temporary bracket made to suspend the oil cooler during  
> earlier brainstorming... (this is the planned location)
> http://i295.photobucket.com/albums/mm133/splitime/Miata%20build% 
> 20pictures/IMG_0521.jpg
> http://i295.photobucket.com/albums/mm133/splitime/Miata%20build% 
> 20pictures/IMG_0522.jpg
>
> Is that sufficient?
> The IC/rad area is ducted on the sides and will be fully sealed off  
> once I finish the rest of the ducting.  All air into opening of  
> bumper, will go through radiator or intercooler.
>
> I'm open to all thoughts ideas... ideally I want to use the current  
> cooler... since I have it... but please feel free to think outside  
> the box.
>
> I had also considered opening up the front bumper even more... hole  
> saw in the remaining area up front... across middle... and putting  
> the oil cooler right in the middle there. (now that I think about  
> that one... I kinda like it again... hurm....)
> front bumper view, picture holes right below the bumper line:
> http://i295.photobucket.com/albums/mm133/splitime/Miata%20build% 
> 20pictures/IMG_0130.jpg
>
> -Dave
> _______________________________________________
> Miatapower mailing list
> [email protected]
> http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower

_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower

Reply via email to