The feed on the driver side is into the top of the radiator.  The bottom of
the radiator is then run along that pipe on the passenger side to the back
of the head.

-Dave

On Tue, May 13, 2008 at 10:24 AM, Murray, Richard <[EMAIL PROTECTED]>
wrote:

> Just out of curiosity; how did you bleed the air out of that setup, with
> both inlet and outlet at the bottom?
>
> -----Original Message-----
> From: [EMAIL PROTECTED] [mailto:
> [EMAIL PROTECTED] On Behalf Of Rob Ebersol
> Sent: Monday, 12 May, 2008 14:12
> To: Dave Ott
> Cc: Miata Power List
> Subject: Re: Oil cooler location (not the typical layout to work with)
>
>
> I don't think you'll need it out front. Not if it's getting air flow in
> the mockup position.
>
> I've got mine (tiny) mounted up in the nose with a small scoop (no direct
> air flow) and it's dropping temps 40f from no oil cooler at all. Peak temps
> after good 20 minutes of consecutive boosted runs showed a peak <230f.
> That's on a 2.0L engine with less than 5qts total capacity (with cooler). My
> lines and cooler probably add another 2/3rds quart.
>
> Here's the current position:
>
> http://i158.photobucket.com/albums/t86/m2cupcar/current%20FEmx5t/baseshroud5.jpg
>
> that works fine for street beatings, but my plans for track prep are going
> to be a Mercedes oil cooler next to my big rad a la "twincooler". That'll
> give me close to the same cooler capacity as the rx7 AND direct air flow
> from the mouth.
>
> On May 12, 2008, at 2:00 PM, Dave Ott wrote:
>
> > I do not have a target oil temp at this point (from my last oil cooler
> > setup on another car... i don't even remember my aims then).  Mainly
> > this is a desire to just not cook my oil and keep everything running.
> > Heck, my entire v-mount system was built as preventative maintenance.
> >
> > The "right behind the middle of bumper" idea is kind of leading me
> > now.  We still have to put in a tubular bumper bar... and I could
> > mount it off that.  It'll heat the air going to rad/ic some... but i
> > can't see it doing that much harm.
>
> _______________________________________________
> Miatapower mailing list
> [email protected]
> http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower
> _______________________________________________
> Miatapower mailing list
> [email protected]
> http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower
>
_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower

Reply via email to