Just out of curiosity; how did you bleed the air out of that setup, with both 
inlet and outlet at the bottom?

-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Rob Ebersol
Sent: Monday, 12 May, 2008 14:12
To: Dave Ott
Cc: Miata Power List
Subject: Re: Oil cooler location (not the typical layout to work with)


I don't think you'll need it out front. Not if it's getting air flow in the 
mockup position.

I've got mine (tiny) mounted up in the nose with a small scoop (no direct air 
flow) and it's dropping temps 40f from no oil cooler at all. Peak temps after 
good 20 minutes of consecutive boosted runs showed a peak <230f. That's on a 
2.0L engine with less than 5qts total capacity (with cooler). My lines and 
cooler probably add another 2/3rds quart.

Here's the current position:
http://i158.photobucket.com/albums/t86/m2cupcar/current%20FEmx5t/baseshroud5.jpg

that works fine for street beatings, but my plans for track prep are going to 
be a Mercedes oil cooler next to my big rad a la "twincooler". That'll give me 
close to the same cooler capacity as the rx7 AND direct air flow from the mouth.

On May 12, 2008, at 2:00 PM, Dave Ott wrote:

> I do not have a target oil temp at this point (from my last oil cooler 
> setup on another car... i don't even remember my aims then).  Mainly 
> this is a desire to just not cook my oil and keep everything running.  
> Heck, my entire v-mount system was built as preventative maintenance.
>
> The "right behind the middle of bumper" idea is kind of leading me 
> now.  We still have to put in a tubular bumper bar... and I could 
> mount it off that.  It'll heat the air going to rad/ic some... but i 
> can't see it doing that much harm.

_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower
_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower

Reply via email to