Interesting point... even when oil flows through it, there likely will be a large air pocket still in the cooler, reducing efficiency.
I have mine sitting sideways, fed from the bottom (in the STi), so air is pushed up and out. www.grayforge.com/axis/IMG_0785.JPG Also in this image is the check valve for the Accusump. Russ -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Murray, Richard Sent: Tuesday, May 13, 2008 8:25 AM To: Rob Ebersol Cc: Miata Power List Subject: RE: Oil cooler location (not the typical layout to work with) Just out of curiosity; how did you bleed the air out of that setup, with both inlet and outlet at the bottom? -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Rob Ebersol Sent: Monday, 12 May, 2008 14:12 To: Dave Ott Cc: Miata Power List Subject: Re: Oil cooler location (not the typical layout to work with) I don't think you'll need it out front. Not if it's getting air flow in the mockup position. I've got mine (tiny) mounted up in the nose with a small scoop (no direct air flow) and it's dropping temps 40f from no oil cooler at all. Peak temps after good 20 minutes of consecutive boosted runs showed a peak <230f. That's on a 2.0L engine with less than 5qts total capacity (with cooler). My lines and cooler probably add another 2/3rds quart. Here's the current position: http://i158.photobucket.com/albums/t86/m2cupcar/current%20FEmx5t/baseshroud5 .jpg that works fine for street beatings, but my plans for track prep are going to be a Mercedes oil cooler next to my big rad a la "twincooler". That'll give me close to the same cooler capacity as the rx7 AND direct air flow from the mouth. On May 12, 2008, at 2:00 PM, Dave Ott wrote: > I do not have a target oil temp at this point (from my last oil cooler > setup on another car... i don't even remember my aims then). Mainly > this is a desire to just not cook my oil and keep everything running. > Heck, my entire v-mount system was built as preventative maintenance. > > The "right behind the middle of bumper" idea is kind of leading me > now. We still have to put in a tubular bumper bar... and I could > mount it off that. It'll heat the air going to rad/ic some... but i > can't see it doing that much harm. _______________________________________________ Miatapower mailing list [email protected] http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower _______________________________________________ Miatapower mailing list [email protected] http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower _______________________________________________ Miatapower mailing list [email protected] http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower
