Bryan Bernesi wrote:

> Hello everyone,
>
> Once again my board will not route.
>
> - I have a single schematic project.
> - I have run ERC, no errors
> - I made my PCB template using the board wizard
> - I have placed all components
> - I have run the DRC, no errors
> - All my layers are set up
>
> When I run the autorouter it stops after initializing.
>
> Is there a way to systematically troubleshoot and find out the reason why the 
>autorouter stops without resorting to maybe this or guess that, trial and error 
>methods?

There must be a keepout line (or fill) enclosing the routing area.  there must be
no arcs on the keepout layer.  These are the killers for the autorouter - it can't
handle these conditions.

Jon

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To join or leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
*                      - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to