First off I would like to thank EVERYONE who offered to take a look at my
board.
Colby,
THANK YOU VERY MUCH!!
After reading your email, I scanned my board at almost maximum zoom and
noticed that I had accidentally drawn a component silkscreen on the
MultiLayer. very hard to catch by the naked eye due to the default color
settings. Top overlay is white, and the MultiLayer is grey.
I am going to change the color setting on the MultiLAyer to Fluoresant Pink
or anything else that is easy to see so I can avoid this problem in the
future.
:)
Very kind regards,
Bryan Bernesi
----- Original Message -----
From: "Colby - PowerStream" <[EMAIL PROTECTED]>
To: "Protel EDA Forum" <[EMAIL PROTECTED]>
Sent: Wednesday, March 28, 2001 5:33 PM
Subject: Re: [PEDA] BOARD WILL NOT ROUTE
> A few things off the top of my head that can cause the router to fail that
I
> did not see mentioned yet..
>
> Tracks on the Multilayer.
>
> Polygons - These are sometimes 0 point polygons... which means you cannot
> see them. To find out if you have 0 point polygons do an Edit--Export to
> spread and if polygons show as an option export them. Then inspect the
> spread sheet and check the point counts.
>
> It is also a good idea to reset the Autoroute server after a failed
> initialization.
>
> I am also open to taking a look at the file for you if you feel you want
to
> send it directly to me.
> ----------------------------------------------------------------------
> Colby Siemer ** Custom Battery Chargers
> ** Custom Power Supplies
> PowerStream Technology ** Custom UPS
> 140 S. Mountainway Drive ** Custom DC/DC Converters
> Orem Utah 84058 ** Power management electronics for OEMs
>
> http://www.PowerStream.com
>
>
> ----- Original Message -----
> From: "David W. Gulley" <[EMAIL PROTECTED]>
> To: "Protel EDA Forum" <[EMAIL PROTECTED]>
> Sent: Wednesday, March 28, 2001 2:52 PM
> Subject: Re: [PEDA] BOARD WILL NOT ROUTE
>
>
> > Bryan Bernesi wrote:
> > >
> > > Hello everyone,
> > >
> > > Once again my board will not route.
> > >
> > > - I have a single schematic project.
> > > - I have run ERC, no errors
> > > - I made my PCB template using the board wizard
> > > - I have placed all components
> > > - I have run the DRC, no errors
> > > - All my layers are set up
> > >
> > > When I run the autorouter it stops after initializing.
> > >
> > > Is there a way to systematically troubleshoot and find out the
> > > reason why the autorouter stops without resorting to maybe this
> > > or guess that, trial and error methods?
>
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To join or leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *