Hello Mr.Price,

Thank you for the tip, but I have no DRC errors. I tried reseting the flags
but the board will still not route.

Bryan
----- Original Message -----
From: "Gordon Price" <[EMAIL PROTECTED]>
To: "'Protel EDA Forum'" <[EMAIL PROTECTED]>
Sent: Wednesday, March 28, 2001 4:46 PM
Subject: Re: [PEDA] BOARD WILL NOT ROUTE


> I had a similar problem a few weeks ago and I was advised that I needed to
> reset the DRC error flags. This may not be your problem, but it definitely
> was my problem. I had the identical symptom. I reset the error flags and
the
> router started working again!
>
> Good Luck,
> R. Gordon Price
>
> -----Original Message-----
> From: Bryan Bernesi [mailto:[EMAIL PROTECTED]]
> Sent: Wednesday, March 28, 2001 4:06 PM
> To: [EMAIL PROTECTED]
> Subject: [PEDA] BOARD WILL NOT ROUTE
>
>
> Hello everyone,
>
> Once again my board will not route.
>
> - I have a single schematic project.
> - I have run ERC, no errors
> - I made my PCB template using the board wizard
> - I have placed all components
> - I have run the DRC, no errors
> - All my layers are set up
>
> When I run the autorouter it stops after initializing.
>
> Is there a way to systematically troubleshoot and find out the reason why
> the autorouter stops without resorting to maybe this or guess that, trial
> and error methods?
>
>
>
>


* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To join or leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
*                      - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to