A few things off the top of my head that can cause the router to fail that I
did not see mentioned yet..
Tracks on the Multilayer.
Polygons - These are sometimes 0 point polygons... which means you cannot
see them. To find out if you have 0 point polygons do an Edit--Export to
spread and if polygons show as an option export them. Then inspect the
spread sheet and check the point counts.
It is also a good idea to reset the Autoroute server after a failed
initialization.
I am also open to taking a look at the file for you if you feel you want to
send it directly to me.
----------------------------------------------------------------------
Colby Siemer ** Custom Battery Chargers
** Custom Power Supplies
PowerStream Technology ** Custom UPS
140 S. Mountainway Drive ** Custom DC/DC Converters
Orem Utah 84058 ** Power management electronics for OEMs
http://www.PowerStream.com
----- Original Message -----
From: "David W. Gulley" <[EMAIL PROTECTED]>
To: "Protel EDA Forum" <[EMAIL PROTECTED]>
Sent: Wednesday, March 28, 2001 2:52 PM
Subject: Re: [PEDA] BOARD WILL NOT ROUTE
> Bryan Bernesi wrote:
> >
> > Hello everyone,
> >
> > Once again my board will not route.
> >
> > - I have a single schematic project.
> > - I have run ERC, no errors
> > - I made my PCB template using the board wizard
> > - I have placed all components
> > - I have run the DRC, no errors
> > - All my layers are set up
> >
> > When I run the autorouter it stops after initializing.
> >
> > Is there a way to systematically troubleshoot and find out the
> > reason why the autorouter stops without resorting to maybe this
> > or guess that, trial and error methods?
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To join or leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *