Ok, I know this is a no-brainer but this afternoon that suits me just fine, I seem to be short some grey matter. Where within Protel does it check for double drill hits? I know that sometime in the past I have had this flagged when doing a design or outputting fab files. However I just got word that a number of designs that were panelized while I was gone, had many double hits on the drills. To solve this in the future, I am trying to find the correct design rule, or check point to ensure that everyone else is using this facility to check their boards. The problem is that I just can't find it at the moment.
Sincerely, Brad Velander. Lead PCB Designer Norsat International Inc. #300 - 4401 Still Creek Drive, Burnaby, B.C., Canada, V5C 6G9. Tel (604) 292-9089 (direct line) Fax (604) 292-9010 Website: www.norsat.com * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
