hey Mike i think we're not busy enough!
Dennis Saputelli
Mike Reagan wrote:
>
> > Where within Protel does it check for double drill hits?
> > I know that sometime in the past I have had this flagged when doing a
> design
>
> Brad,
> Design Rules, Clearance rule, Add, oject kind , vias, set clearance to 0,
> and use any net. Somewhere in Protel's knowledge base item it is listed,
> sorry I don't remember the item number. But the Item number is almost
> correct. YOU MUST disable this rule after using it then run drcs again
> with your other rules or you will have manufacturing clearance violations.
>
> Mike Reagan
> EDSI
>
--
___________________________________________________________________________
www.integratedcontrolsinc.com Integrated Controls, Inc.
tel: 415-647-0480 2851 21st Street
fax: 415-647-3003 San Francisco, CA 94110
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
