Brendon,
        I thought that Protel typically reported this in the drill report
file? Am I going looney tunes, because I can't seem to make it work on these
boards that reportedly have the double hits.
        I know my previous exposure is not from an add-on server because I
have never installed that server. Where should I find the server, the
Association archive, Protel or is it at the mercy of some individual who
developed it?

Sincerely,
Brad Velander.

Lead PCB Designer
Norsat International Inc.
#300 - 4401 Still Creek Drive,
Burnaby, B.C., Canada, V5C 6G9.
Tel   (604) 292-9089 (direct line)
Fax  (604) 292-9010
Website: www.norsat.com


-----Original Message-----
From: Brendon Slade [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, November 21, 2001 5:03 PM
To: Protel EDA Forum
Subject: Re: [PEDA] Where does Protel check or flag double hits on
drills?


There is an add-on Hole Detector server that performs this trick I think.

Cheers,
Brendon.

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to