what is the point below which you cannot put solder mask between smd
pads
that is, what have you all found is too thin a sliver of mask to fab?
i'm thinking that 6-8 mils is about it and below that you have to mask
out the whole area
Dennis Saputelli
--
___________________________________________________________________________
www.integratedcontrolsinc.com Integrated Controls, Inc.
tel: 415-647-0480 2851 21st Street
fax: 415-647-3003 San Francisco, CA 94110
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
