It is from CO, and most of the tip/ring tracks are separated more than that, but the SMT jack we use (from AMP) has only a 15mil gap between the pads, so the rule for that part of the net has to accomodate that spacing.
-----Original Message----- From: Bob Wolfe [mailto:[EMAIL PROTECTED]] Sent: Saturday, January 26, 2002 10:22 AM To: Protel EDA Forum Subject: Re: [PEDA] Auto router Dwight, Unrelated to actual Router Setup but, Just a question only .015 inch gap for Tip & Ring to all other nets, that might be good for between Tip and Ring???? Or is it not the actual Tip & Ring coming directly from CO but rather further down stream that connects to some sort of system station card then ultimately to a phone??? Bob Robert M. Wolfe, C.I.D. <snip> > Clearance Constraint : > Enabled = Yes Name = TipRingClearance > Scope1 = TipRingVoltage > Scope2 = Board > Connectivity = Different Nets > Gap = 15mil > Rule Followed By Router <snip> * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
