(this is all 99SE)
so i have some plated holes that are 39 mils
i have some plated slots that are 1mm
the hole size editor will only select the 39 mil holes
which i guess is as it should be, BUT
the CAM NC output lumps the 1mm center hole of the slot with the 39 mil
holes
i realize the difference is negligible, but i want a different tool
number for the 1mm slots in the NC drill file
i seem to remember in some past version a way to set the point at which
holes were grouped
(minimum dia. difference or something like that) but i don't see it now
i wound up changing the 39 holes to 38 to force a new tool, but it would
be nice if the
Select Hole Size editor showed what the PCB:GenerateNCDrill process was
doing
BTW - a buglet found (or just noticed)
if you go to customize menu item
change a process and then hit the escape key, the process is changed!
not exactly what i wanted to happen
Dennis Saputelli
************************************************************************
* Tracking #: 012D5A769B78F04392D45DFF2DF810B7B219095A
*
************************************************************************
--
___________________________________________________________________________
www.integratedcontrolsinc.com Integrated Controls, Inc.
tel: 415-647-0480 2851 21st Street
fax: 415-647-3003 San Francisco, CA 94110
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
