Or Bottom Layer, depends on your board.

Igor

-----Original Message-----
From: Igor Gmitrovic 
Sent: Friday, 20 September 2002 11:09 AM
To: Protel EDA Forum
Subject: Re: [PEDA] Unplated pads


Just make them Top Layer pads.

Igor

-----Original Message-----
From: Thomas [mailto:[EMAIL PROTECTED]]
Sent: Friday, 20 September 2002 10:34 AM
To: Protel Data Forum (E-mail)
Subject: [PEDA] Unplated pads


Our board house has asked us to de-check the "Plated" box for single sided
pads.
Ok, 1 global edit later and it's done, only one problem the DRC now comes up
with:

Processing Rule : Broken-Net Constraint ( (On the board ) )
   Violation         Net A
     Warning - net contains unplated pads
   Violation         Net N/E
     Warning - net contains unplated pads
   Violation         Net A1
     Warning - net contains unplated pads
etc...

I realise these are warnings rather than full blown violations but is there
any way
to turn this warning reporting off in the DRC report?

Thanks,

Tom.

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to