Tony,
        what about vice-versa to your comment below? PCB copper features in
schematic that you don't want in the BOM.
Previously one could leave the part type field blank to drop something from
the BOM but this was not always the best or cleanest solution.

Sincerely,
Brad Velander.

Lead PCB Designer
Norsat International Inc.
Microwave Products
Tel   (604) 292-9089 (direct line)
Fax  (604) 292-9010
email: [EMAIL PROTECTED]
http://www.norsat.com

Check out our fall promotion at www.norsat.com. Limited quantities. Sale
ends December 24, 2002.
Contact your Account Manager or call 1-800-NII-4LNB or email
[EMAIL PROTECTED]



> -----Original Message-----
> From: Tony Karavidas [mailto:[EMAIL PROTECTED]]
> Sent: Monday, December 02, 2002 9:38 PM
> To: 'Protel EDA Forum'
> Subject: Re: [PEDA] 10 best options I want
> 
> 
<SNIP>
> 
> Mechanical component type in SCH...keeps some things from ending up on
> the PCB but still remain in BOM.

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to