I've done quite a bit of this and the only way I could get a tighter 'fit' was to scale everything up.
On 12 April 2016 at 21:28, Jason S <[email protected]> wrote: > In case you might have missed it or if it would make a difference, but > there are polygonizer settings under both the generated polygonizer mesh, > as well as the existing polygonized elements. > (only the generated polygonizer mesh setting popup when aplying it) > > > On 04/12/16 15:00, Kris Rivel wrote: > > Thanks guys...just seems like the built in polygonizer has a limit to how > "tight" it can create a mesh around very small particles. I just need to > maybe scale the character up, simulate, than maybe shrink it down. > > On Fri, Apr 8, 2016 at 5:26 PM, Steven Caron <[email protected]> wrote: > >> For particles below some threshold just render them as spheres? >> >> *written with my thumbs >> On Apr 8, 2016 1:00 PM, "Kris Rivel" <[email protected]> wrote: >> >>> So I have some small particles I want to polygonize. Using the built in >>> version. I can't seem to get the mesh really tight/close to the particles. >>> I can get there a bit with some insane settings but its too slow and not >>> close enough. Is it sensitive to particle size in relation to SI units? Do >>> they need to be larger? >>> >>> Kris >>> >>> ------ >>> Softimage Mailing List. >>> To unsubscribe, send a mail to [email protected] >>> with "unsubscribe" in the subject, and reply to confirm. >>> >> >> ------ >> Softimage Mailing List. >> To unsubscribe, send a mail to [email protected] >> with "unsubscribe" in the subject, and reply to confirm. >> > > > > ------ > Softimage Mailing List. > To unsubscribe, send a mail to [email protected] with > "unsubscribe" in the subject, and reply to confirm. > > > > ------ > Softimage Mailing List. > To unsubscribe, send a mail to [email protected] > with "unsubscribe" in the subject, and reply to confirm. > -- Chris Marshall Mint Motion Limited 029 20 37 27 57 07730 533 115 www.mintmotion.co.uk www.dot3d.com
------ Softimage Mailing List. To unsubscribe, send a mail to [email protected] with "unsubscribe" in the subject, and reply to confirm.
