Send me a picture direct to my email. I may have one. Bert Kehren In a message dated 10/22/2010 6:01:13 P.M. Eastern Daylight Time, as ma...@fc.up.pt writes:
With an outboard +/- 12 Volt power source my 2100F is now working fine. A new replacement package is therefore desperately needed. Best regards, Antonio CT1TE Quoting asma...@fc.up.pt: > Dear All, > > Diving into the hardware, I found the DC-DC +5 to +/-12 V Power Source > defective. There may be something more but that is serious enough. > > Thank you for your kind attention and help. > > Antonio > CT1TE > > Quoting paul swed <paulsw...@gmail.com>: > >> Thats what I was thinking also on the reference and emailed back to the >> group. >> I believe over time that internal switch to select 1,5,10 mc can get a bit >> touchy. >> If a operating reference is connected and checked to be correct toggle the >> switch a few times to clean its contacts. It gets lonely sitting in there by >> itself for years. ;-) >> Regards >> Paul. >> >> On Fri, Oct 22, 2010 at 8:12 AM, Chuck Harris <cfhar...@erols.com> wrote: >> >>> Hi Antonio, >>> >>> Ok. I just wanted to be sure that it was still up in Europe. Canada >>> dropped their chains 3 months earlier than they said they would. And >>> since Loran-C is no longer usable world wide, I figure Europe will be >>> dropping their chain soon. >>> >>> The error indication you have described tells me that you have no >>> reference oscillator. This could be for a couple of reasons: >>> >>> 1) you have no frequency standard connected to your 2100F >>> 2) the switch, labeled 1-5-10, on the board stack visible when you hinge >>> open the front panel is set incorrectly for your external frequency >>> standard. >>> 3) Your 2100F is broken. >>> >>> -Chuck Harris >>> >>> asma...@fc.up.pt wrote: >>> >>>> Chuck, >>>> >>>> I am in Portugal, currently receiving the European >>>> 6731 LESSAY Chain. >>>> >>>> Best regards, >>>> Antonio >>>> CT1TE >>>> >>>> Quoting Chuck Harris <cfhar...@erols.com>: >>>> >>>> Are you sure that your Loran chain is still up? In the US and >>>>> Canada, Loran has been decommissioned. >>>>> >>>> >>> _______________________________________________ >>> time-nuts mailing list -- time-nuts@febo.com >>> To unsubscribe, go to >>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >>> and follow the instructions there. >>> >> _______________________________________________ >> time-nuts mailing list -- time-nuts@febo.com >> To unsubscribe, go to >> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. >> _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.