So what we need is a Syncinjector with jumpers like on the Gigabit PoE injectors...
On Thu, Apr 16, 2015 at 6:57 PM, Josh Luthman <j...@imaginenetworksllc.com> wrote: > Yup screwed there :( > > Josh Luthman > Office: 937-552-2340 > Direct: 937-552-2343 > 1100 Wayne St > Suite 1337 > Troy, OH 45373 > On Apr 16, 2015 7:42 PM, "Mathew Howard" <mhoward...@gmail.com> wrote: > >> If I remember right, the AF5x pinout is 1/2 & 4/5 positive and 3/6 & 7/8 >> negative. >> >> Airmax stuff is all 4/5 positive and 7/8 negative, I imagine the 10/100 >> stuff would work fine with the power pairs swapped, but I don't know what >> that would do to gigabit. I don't think it's going to work with AF5x, since >> they use power on all four pairs. >> >> On Thu, Apr 16, 2015 at 6:19 PM, Josh Luthman < >> j...@imaginenetworksllc.com> wrote: >> >>> I didn't check...sorry. It's on the roof so I can go up and look >>> tomorrow. >>> >>> >>> Josh Luthman >>> Office: 937-552-2340 >>> Direct: 937-552-2343 >>> 1100 Wayne St >>> Suite 1337 >>> Troy, OH 45373 >>> >>> On Thu, Apr 16, 2015 at 7:14 PM, George Skorup (Cyber Broadcasting) < >>> geo...@cbcast.com> wrote: >>> >>>> No pinout!? >>>> >>>> On 4/16/2015 6:10 PM, Josh Luthman wrote: >>>> >>>> It says 24v/1a and is gigabit. It is a bit different than the Nanobeam >>>> POEs. It also doesn't work with an NSM5 for certain. >>>> >>>> >>>> Josh Luthman >>>> Office: 937-552-2340 >>>> Direct: 937-552-2343 >>>> 1100 Wayne St >>>> Suite 1337 >>>> Troy, OH 45373 >>>> >>>> On Thu, Apr 16, 2015 at 6:39 PM, George Skorup (Cyber Broadcasting) < >>>> geo...@cbcast.com> wrote: >>>> >>>>> What does the AF5x power supply say on the label for pairs or >>>>> pinouts? Or is it the same as their other 24V/1A supplies, but gigabit? >>>>> >>>>> On 4/16/2015 5:29 PM, Josh Luthman wrote: >>>>> >>>>> I'm mostly concerned with the Ubnt Airmax stuff (24v) and AF5x. >>>>> Obviously the ePMP works. >>>>> >>>>> >>>>> Josh Luthman >>>>> Office: 937-552-2340 >>>>> Direct: 937-552-2343 >>>>> 1100 Wayne St >>>>> Suite 1337 >>>>> Troy, OH 45373 >>>>> >>>>> On Thu, Apr 16, 2015 at 6:12 PM, George Skorup (Cyber Broadcasting) < >>>>> geo...@cbcast.com> wrote: >>>>> >>>>>> AFAIK, the 450AP GigE interface is still powered only on pins 4, 5, 7 >>>>>> & 8. Probably applies to the ePMP Sync radio too. >>>>>> >>>>>> So, with that in mind.. does the UBNT GigE PoE stuff use all 4 pairs >>>>>> for power? If it's 4, 5, 7 & 8, it may be possible, but... you'd have to >>>>>> flip the blues and browns at one end. I don't know what that would do for >>>>>> the GigE data interface though. It might not work. You can use a 568B to >>>>>> 568A (aka standard cross-over) cable and GigE still works fine, but I'm >>>>>> not >>>>>> sure about crossed blues and browns. >>>>>> >>>>>> Someone smarter than me would probably have to give you a thumbs up >>>>>> or down. >>>>>> >>>>>> >>>>>> On 4/16/2015 4:55 PM, Josh Luthman wrote: >>>>>> >>>>>>> Has anyone tried these syncinjectors for Ubnt Airmax radios? What >>>>>>> about anything else? I'd love to use this one product for all sites >>>>>>> from >>>>>>> now on. >>>>>>> >>>>>>> Is it possible to run the AF5x? >>>>>>> >>>>>>> Josh Luthman >>>>>>> Office: 937-552-2340 >>>>>>> Direct: 937-552-2343 >>>>>>> 1100 Wayne St >>>>>>> Suite 1337 >>>>>>> Troy, OH 45373 >>>>>>> >>>>>> >>>>>> >>>>> >>>>> >>>> >>>> >>> >>