Which means the 3400 CPU and not the switching engine is forwarding the packets... how many routes are you trying to feed the 3400 ?
Rubens On Wed, Apr 14, 2010 at 1:40 PM, Jeremy Parr <[email protected]> wrote: > On 14 April 2010 11:57, Jeremy Parr <[email protected]> wrote: >> I have an ME3400 running 12.2(46)SE that will not pass (much) more >> than 1000pps through its copper gig port. The interface counters hover >> around 1000pps tx/rx, while the bps rate fluctuates (presumable due to >> the variable packet sizes getting thrown at it). There are no service >> policys or rate limits applied to any of the interfaces. Any thoughts? >> >> 5 minute input rate 1681000 bits/sec, 879 packets/sec >> 5 minute output rate 7545000 bits/sec, 1012 packets/sec > > I am also seeing the following in the logs.... > > %PLATFORM_UCAST-6-PREFIX: One or more, more specific prefixes could > not be programmed into TCAM and are being covered by a less specific > prefix > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
