On Wed, Apr 14, 2010 at 12:40:46PM -0400, Jeremy Parr wrote: > On 14 April 2010 11:57, Jeremy Parr <[email protected]> wrote: > > I have an ME3400 running 12.2(46)SE that will not pass (much) more > > than 1000pps through its copper gig port. The interface counters hover > > around 1000pps tx/rx, while the bps rate fluctuates (presumable due to > > the variable packet sizes getting thrown at it). There are no service > > policys or rate limits applied to any of the interfaces. Any thoughts? > > > > ?5 minute input rate 1681000 bits/sec, 879 packets/sec > > ?5 minute output rate 7545000 bits/sec, 1012 packets/sec > > I am also seeing the following in the logs.... > > %PLATFORM_UCAST-6-PREFIX: One or more, more specific prefixes could > not be programmed into TCAM and are being covered by a less specific > prefix
I hit that warning as well, IOS is 12.2(53)SE, and the routing table is not huge. If you ever find a clue, let me know... ME3400#sh ip route summary IP routing table name is Default-IP-Routing-Table(0) IP routing table maximum-paths is 32 Route Source Networks Subnets Overhead Memory (bytes) connected 1 3 256 608 static 0 2 192 304 internal 3 3516 Total 4 5 448 4428 ME3400# ME3400#sh ip cef summary IPv4 CEF is enabled for distributed and running VRF Default: 30 prefixes (30/0 fwd/non-fwd) Table id 0 Database epoch: 2 (30 entries at this epoch) ME3400# Cheers, Everton _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
