Pete If you are going to replace think about a third battery, solar, inverter. I've seen lots of complaints about the new Xantrex stuff on CF fwiw.
Joel Aronson On Dec 3, 2012, at 1:49 PM, "Dennis C." <[email protected]> wrote: Might be a bit more than needed or wanted but the Blue Sea VSM 422 monitors a lot of systems, AC, DC, amphours consumed, tank levels, etc. Of course you have to buy the sensors you need. Dennis C. Touche' 35-1 #83 Mandeville, LA ------------------------------ *From:* Martin DeYoung <[email protected]> *To:* "[email protected]" <[email protected]> *Sent:* Monday, December 3, 2012 12:25 PM *Subject:* Re: Stus-List xantrex link 20 Pete, I have the Link monitor + 2,500 watt inverter/charger on Calypso. It was manufactured by Heart Interface just about the time Xantrex was acquiring them. A few years back Calypso’s link display failed. At that time Xantrex still had a manufacturing/engineering/repair facility near Seattle . I was able to have a chip replaced and a software upgrade by the repair facility. Since then that whole facility was closed and the work moved offshore. A company named Outback that manufactures alternative energy inverters is now operating out of that building. Xantrex customer service and technical support was less than helpful but they did offer up several “reset” type commands that I had not tried in the past. My guess is Xantrex has lost the ability to service the older Link systems. Since the last repair the “smart” regulator went TU and I now use a 3 stage that is compatible. I sent the failed regulator to a company (tech in a small shop) in Florida to see if it was repairable. After a few conversations regarding the possible issues he disappeared. I have some Link diagnostic info and a copy of the manual somewhere in my files if you are interested. The display will lose a digit or so if left on the same setting all the time or in direct sunlight. To compensate I leave the display on “Batt 2, amperage” which limits the number of digits energized. When I want to check the battery voltage I switch the display over to read the value. This mostly works but it is a short term solution. If you choose another system I am interested in how it works out. Martin Calypso 1970 C&C 43 Seattle ------------------------------ *From:* CnC-List [mailto:[email protected]<[email protected]>] *On Behalf Of *[email protected] *Sent:* Monday, December 03, 2012 9:52 AM *To:* [email protected] *Subject:* Stus-List xantrex link 20 I have two house batteries. No separate starting battery yet. I use a Xantrex Link 20 to monitor voltage/current on each battery and it appears the display has gone belly up. IE I can only see voltage for each battery, no current. Does anyone have trouble shooting ideas/options? I looked at the Xantrex Linkpro as a replacement, but I need to buy two - one for each battery, add an additional shunt, blah, blah, blah. Any other recommendations for a replacement? thanks, Pete _______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com [email protected] _______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com [email protected]
_______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com [email protected]
