I think that's just the way it is
you can do a convert to pads and rebuild
but why do you want it that way?
Dennis Saputelli

Kirk Haderlie wrote:
> 
> We do a ground polygon fill on the top and bottom of our boards.  Has anyone
> been successful getting relief connections on vias?  I have tried a polygon
> connect style design rule that applied only to vias on the GND net but this
> does not work.
> 
> Kirk Haderlie
> Design Engineer
> Vivid Image Technology
> [EMAIL PROTECTED]
> 
> * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
> *  This message sent by: PROTEL EDA USERS MAILING LIST
> *
> *  Use the "reply" command in your email program to
> *  respond to this message.
> *
> *  To unsubscribe from this mailing list use the form at
> *  the Association web site. You will need to give the same
> *  email address you originally used to subscribe (do not
> *  give an alias unless it was used to subscribe).
> *
> *  Visit http://www.techservinc.com/protelusers/subscrib.html
> *  to unsubscribe or to subscribe a new email address.
> * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

-- 
___________________________________________________________________________
www.integratedcontrolsinc.com            Integrated Controls, Inc.    
   tel: 415-647-0480                        2851 21st Street          
      fax: 415-647-3003                        San Francisco, CA 94110



* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
*  This message sent by: PROTEL EDA USERS MAILING LIST
*
*  Use the "reply" command in your email program to
*  respond to this message.
*
*  To unsubscribe from this mailing list use the form at
*  the Association web site. You will need to give the same
*  email address you originally used to subscribe (do not
*  give an alias unless it was used to subscribe).
*
*  Visit http://www.techservinc.com/protelusers/subscrib.html
*  to unsubscribe or to subscribe a new email address.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

________________________________________________________

To leave the EDAFORUM discussion list, send a email with
'leave edaforum' in the body to '[EMAIL PROTECTED]'

More Information : http://www.dolist.net

Reply via email to