> Dennis,
> yes I have been experimenting with rules just like you mention.
> However, it flags any via or pad that touches, doesn't matter about drill
> overlap. Our boards just highlight all over the place in the DRC layer
> color. Not much good. If you were doing regular digital/analog boards
> without via stitching, it may work but not for us. I even tried -7 or -8
> mils just to find anything that definitely overlapped, but it seemed to
take
> the negative value as "0" and highlighted anything that touched.
>

Brad,
So use a work around: gloabally decrease the size of your vias so they dont
touch,  find the double hits using the drc method then globally change them
back.   No one said it was easy.

Mike

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to