I think you are after the tenting function.

To turn this on for all vias go to the properties of one, select tenting,
then make the change globally.

Good luck 

Wayne Bickers
Electronics Engineer
Tru-Test Ltd

> -----Original Message-----
> From: Afshin Salehi [SMTP:[EMAIL PROTECTED]]
> Sent: Friday, 25 January 2002 10:30 a.m.
> To:   Protel Forum
> Subject:      [PEDA] Solder mask over via's
> 
> Hello all,
>       I was wondering how I could have solder mask placed over all the
> via's on
> my PCB.  Is there a design rule for the via's that allow you to select
> solder mask options?  I saw a design rule for via size but not solder
> mask.
> All of my via's should be a different size than any pads so if it were
> necessary I am sure I could select them all and do a global change if that
> is the only way possible.  Some of my via's are placed so close to pads
> after a route that I am afraid of bridging occurring when the PCB is
> soldered.
> 
> Thanks to everyone for your continued help.
> 
> Afshin Salehi
> DPS Telecom

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to