2 two lane edges towards the junction and two three lane ones. Vehicle count is around 20 - 60k in different approaches.
On Wed, 29 May 2019, 5:31 pm Jakob Erdmann, <[email protected]> wrote: > It may help to observe both simulations closely in sumo-gui to see if > there is an obvious difference in behavior indicating a problem in either > of the simulations. > How large is your scenario in terms of intersections,edges,vehicle count? > > Am Mi., 29. Mai 2019 um 10:55 Uhr schrieb rony gracious < > [email protected]>: > >> The flow given was same for both 5 hour simulation. But when I take count >> for every 30 minutes that's where the difference is. The last vehicle in >> sumo enters 2 hours after the last vehicle in meso entered. >> >> Yes. Sorry. I meant junction control. >> >> On Wed, 29 May 2019, 12:30 pm Jakob Erdmann, <[email protected]> >> wrote: >> >>> It's hard to answer this generally. Meso and miro are different models >>> so there will be many situations in which they produce different results. >>> You first have to figure out whether the sumo flow is too low (e.g. due >>> to road nework problems) or whether the the meso flow is too high (which >>> can be due to the used options). >>> There is no meso option called tl-logic (but there is one for tls and >>> one for junction control) so you need to be more precise on the used option. >>> >>> regards, >>> Jakob >>> >>> Am Mi., 29. Mai 2019 um 07:47 Uhr schrieb rony gracious < >>> [email protected]>: >>> >>>> For the same flow sumo is taking around 2 hours of extra simulated time >>>> then meso which accounts for this extra counts. >>>> >>>> On Wed, May 29, 2019 at 11:02 AM rony gracious <[email protected]> >>>> wrote: >>>> >>>>> While I run meso for a 5 hour simulation with loop detectors placed >>>>> there is a considerable difference in vehicle count from when I do the >>>>> same >>>>> with sumo. When I took vehicle count every 30 minutes meso had atleast 100 >>>>> vehicles more than sumo in each time step of 30 minutes. >>>>> >>>>> Can anyone tell me why that is and how I can get more closer to a sumo >>>>> SIM with meso. The only parameters I am using is mesosim true and meso tl >>>>> logic true which is in mesoscopic. >>>>> >>>>> Rony Gracious >>>>> >>>> _______________________________________________ >>>> sumo-user mailing list >>>> [email protected] >>>> To change your delivery options, retrieve your password, or unsubscribe >>>> from this list, visit >>>> https://www.eclipse.org/mailman/listinfo/sumo-user >>>> >>> _______________________________________________ >>> sumo-user mailing list >>> [email protected] >>> To change your delivery options, retrieve your password, or unsubscribe >>> from this list, visit >>> https://www.eclipse.org/mailman/listinfo/sumo-user >>> >> _______________________________________________ >> sumo-user mailing list >> [email protected] >> To change your delivery options, retrieve your password, or unsubscribe >> from this list, visit >> https://www.eclipse.org/mailman/listinfo/sumo-user >> > _______________________________________________ > sumo-user mailing list > [email protected] > To change your delivery options, retrieve your password, or unsubscribe > from this list, visit > https://www.eclipse.org/mailman/listinfo/sumo-user >
_______________________________________________ sumo-user mailing list [email protected] To change your delivery options, retrieve your password, or unsubscribe from this list, visit https://www.eclipse.org/mailman/listinfo/sumo-user
