If it is then I am looking at the wrong git: CRAMPS “https://github.com/machinekit/machinekit/blob/master/configs/ARM/BeagleBone/CRAMPS/CRAMPS.ini” [PRUCONF] DRIVER=hal_pru_generic CONFIG=pru=0 num_stepgens=4 num_pwmgens=6 PRUBIN=xenomai/pru_generic.bin
Xylotex “https://github.com/machinekit/machinekit/blob/master/configs/ARM/BeagleBone/Xylotex/Xylotex.ini <https://github.com/machinekit/machinekit/blob/master/configs/ARM/BeagleBone/Xylotex/Xylotex.ini>” [PRUCONF] DRIVER=hal_pru_generic CONFIG=pru=1 num_stepgens=4 PRUBIN=xenomai/pru_generic.bin > On Aug 30, 2018, at 6:29 PM, Robert Nelson <[email protected]> wrote: > > On Thu, Aug 30, 2018 at 5:55 PM Condit Alan <[email protected]> wrote: >> >> I found a link talking about getting a CRAMPS board working with Stretch. It >> said you need to replace >> #PRUBIN=xenomai/pru_generic.bin >> with >> PRUBIN=rt-preempt/pru_generic.bin. >> >> Does that apply to the Xylotex DB25 cape also? >> >> I tried it in Xylotex.ini but the errors seemed to be the same either way. > > i thought that was fixed in git.. > > Regards, > > -- > Robert Nelson > https://rcn-ee.com/ -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. Visit this group at https://groups.google.com/group/machinekit. For more options, visit https://groups.google.com/d/optout.
