Date: Fri, 25 May 2001 11:59:42 -0700
From: "Ronald C. Dailey" <[EMAIL PROTECTED]>
Subject: Re: rotate dialing
On 2001-05-25 [EMAIL PROTECTED] said:
>Date: Fri, 25 May 2001 22:25:59 +0700
>My nettamer will not accept rote dialing. I have set it up
>so it is able to go through all telephone numbers of my ISP
>but it never worked for me.
>The same version did work when used on another computer
>with a different modem. On this computer I have a 56K Voice
>Fax modem, external from 3Com US Robotics. On the other
>computer a no mark external modem.
OK, what you should do based on my recollection of USR setup, is that
you should set the modem to factory defaults in Net-Tamer by going to
the terminal screen (Alt =) and then entering AT&F1. Note that it is
&F1. That's the preferred default set for a USR. Wait for the modem to
respond with OK, and then enter ATX4 and wait again for the modem to
echo OK to you. Then enter AT&W to save the settings to profile 0.
After the modem responds with OK, exit the terminal (F4). Next, change
the init string in Net-Tamer to just plain "ATZ" and you should be okay.
Most modems don't respond to commands that immediately follow ATZ unless
there is an actual pause before the software sends the other commands.
Ronald Dailey
--
RCD
Net-Tamer V 1.13 Beta - Registered
********************************************************
To unsubscribe from this list,
send a message to [EMAIL PROTECTED] with the single word
Unsubscribe
as the subject.
You MUST use the same address with which you subscribed!
********************************************************
