Hi Guys (and Gals)
I have an error that I can't find in the Protel knowledge database.
When I try to open a ddb, I get the error plaque from windows:
[MICROSFT] [ODBC MICROSOFT ACCESS DRIVER] The microsoft
jet engine stopped the process because you and another are
attempting to
change the same data at the same time.
I am running Protel 99 SE , service pack 5, on windows 98.
I am running standalone. I am tied into a network.
I am the only one here with the software.( I've checked)
I get the same symptom connected to the net or unconnected.
I open Protel, I open a database, ok so far.
I have 4 schematics, and 2 pcbs in this database.
If I open pcb #1, it opens fine.
If I open pcb #2, I get the error.
If I try to load a new set of libraries, I can remove them ok,
buy when I add them, I get the error.
I have rebooted.
I have re-installed Protel.
I have removed all Protel files and Fresh installed, no luck.
I have sent a message to "support", but have not heard anything yet.
Just a curious point, when I called Protel on the phone, I talked to
a
person who told me: "Yeah, we get that all the time, but I don't
know
what it is."
Thanks in advance for any ideas.
Bob Fearon
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* This message sent by: PROTEL EDA USERS MAILING LIST
*
* Use the "reply" command in your email program to
* respond to this message.
*
* To unsubscribe from this mailing list use the form at
* the Association web site. You will need to give the same
* email address you originally used to subscribe (do not
* give an alias unless it was used to subscribe).
*
* Visit http://www.techservinc.com/protelusers/subscrib.html
* to unsubscribe or to subscribe a new email address.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
________________________________________________________
To leave the EDAFORUM discussion list, send a email with
'leave edaforum' in the body to '[EMAIL PROTECTED]'
More Information : http://www.dolist.net