What car is the engine and wiring from ?
Are you sure it's not the road speed sensor connector (fitted onto gearbox
speedo drive), a 3 pin connector.
The coil should have 12v ignition on the centre pin.
The outer 2 pins will also be 12v but will drop while the engine is running.
The engine wasn't from an automatic was it ?
Jim
--------------------------------------------------
From: "taximark" <[email protected]>
Sent: Friday, May 20, 2011 1:47 PM
To: "Quantum Owners Group" <[email protected]>
Subject: [Quantum Owners] Re: 2+2 Zetec conversion
First major hiccup, the engine is in, the looms are spliced but there
is still no spark. There is a connector on the new loom for an engine
speed sensor( labelled as such), but appears to be none on the new
engine. The crank position sensor and the cam phase sensor are both
connected. Any suggestions on whether this is a major issue. the coil
pack has three wires going to it, does anyone know what the voltages
should be on these three wires?
Thanks for your advice
mark
--
You received this message because you are subscribed to the Google Groups "Quantum
Owners Group" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to
[email protected]
For more options, visit this group at
http://groups.google.com/group/quantumowners?hl=en
IMPORTANT NOTE: All information presented herewith is provided on an "As Is"
basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor
the individuals associated with the Quantum Owners Club or in the preparation of the
above information shall have any liability to any person or entity with respect to
liability, loss, or damage caused or alleged to be caused directly or indirectly by the
instructions contained within this or related message(s).
