Hi Nigel, Very interesting indeed … unless this is the old MIST device… but it is doubtful that proton fusion is involved, even if there has been a breakthrough - especially without measureable radiation.
Did you see any kind of radiation signature? The main problem with a similar older technology has been lack of measurement of all the subsystems. I am assuming that what you are working with is derived from the system being promoted by Richard Aho, once called MIST: http://www.rexresearch.com/ahomist/ahomist.htm My associates visited the facility in Florida several years ago, and came away very disappointed since they had been promised to be shown a working device. Despite all the talk, there was no engine then which could actually run by itself on water/steam. There were many, many excuses but AFAIK it looks good on paper but has not been shown to actually run without another system supplying the very high pressure required by the injectors. Perhaps there has been a bona fide breakthrough and things have changed, but … $64 question … Have you actually seen it running on water/steam without electrical input and without another system supplying the high pressure water? If so, for how long? Jones From: Nigel Dyer For some months I have been working with Cavitation Energy Systems (http://cavitationenergysystems.com/) who have been developing an efficient steam generator based on cavitation. What is not obvious until you start going through the details of what they say on the website is that there appears to be five times more energy in the steam they produce than the electrical energy they use to produce it. I have met up with them in Florida and gone through the details of the system and it does appear to be as they claim. The question is how does it manage to do this? By combining knowledge of their system with other 'excess energy' systems that I am aware of and had dealings with I think the mechanism is as follows: • As they intended, they use a diesel injector to create a pulse of water that is full of cavitation bubbles. • When the pulse hits a nearby surface a shock wave travels back through the water initiating an almost synchronous collapse of all the bubbles. • The potential differences within the collapsing bubbles accelerate some free protons such that they have an energy of the order of 10kV, enough to overcome the coulomb barrier and initiate fusion. • The fusion energy is carried away by a virtual neutrino, and there is a cascade of virtual neutrinos which distribute the energy as kinetic energy among nearby protons and electrons. Some of the protons have sufficient energy to initiate a secondary fusion event starting a short duration chain reaction. With others the kinetic energy they gain is transferred to the water molecule and consequently the water is heated up until it boils. The way that the bubbles collapse directs the energy away from the surface, avoiding the normal problems of cavitation systems where the cavitation causes damage to surfaces. The way that the shock wave causes all the bubbles to collapse and initiate fusion at close to the same time means that the energy from the proton-proton fusion is able to heat all of the water, converting it to steam, at which point the chain reaction stops. Not only do they appear to have significant energy gain but it is available in a highly usable form, as high temperature steam. I have put together some more detailed notes. http://thedyers.org.uk/wp-content/uploads/2017/09/CES_LENR.pdf Nigel