Steve's correct. The Synchroniser cannot find pin 2 on ref designator device
FS1. This could be because there is no pin 2, pin 2 in the footprint may be
pin A instead, etc.. Basically, it can't find the pin to make the netlist
connection to. Possibly this results from not being able to find the
footprint at all, that should have generated another error when it couldn't
find the footprint though.

Sincerely,
Brad Velander.

Lead PCB Designer
Norsat International Inc.
#300 - 4401 Still Creek Drive,
Burnaby, B.C., Canada, V5C 6G9.
Tel   (604) 292-9089 (direct line)
Fax  (604) 292-9010
Website: www.norsat.com


-----Original Message-----
From: Steve Smith [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, November 14, 2001 12:59 PM
To: 'Protel EDA Forum'
Subject: Re: [PEDA] None


I believe it's telling you that it can't find pin 2
on your PCB footprint.

Steve Smith
Product Engineer
Staco Energy Products Co.
Web Site: www.stacoenergy.com


* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to