Rusty,
hearing your comments below, I am sure that this is the same bug. It
must occur similarly with all PCB primitives that come in contact with
polygon pours. I have seen it with both lines/tracks and pads.
Sincerely,
Brad Velander.
Lead PCB Designer
Norsat International Inc.
Microwave Products
Tel (604) 292-9089 (direct line)
Fax (604) 292-9010
email: [EMAIL PROTECTED]
http://www.norsat.com
Norsat's Microwave Products Division has now achieved ISO 9001:2000
certification
> -----Original Message-----
> From: Rusty Land [mailto:[EMAIL PROTECTED]]
> Sent: Tuesday, October 15, 2002 9:28 AM
> To: Protel EDA Forum
> Subject: Re: [PEDA] Keepout Fills Not Working After Movement 99SE
>
>
> All the fills started out as "No Net", the fills that
> would not work
> took on the GND net. There was no obvious reason like
> overlapping vias that
> would explain why they did. I'll try the close-open DDB trick
> next time.
>
> Thanks, Rusty Land
>
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
