Ivan, are you figuring the connectors are right-angle? The original post indicates they are straight, so a cable on one side won't interfere with the cable on the other side.
> -----Original Message----- > From: Bagotronix Tech Support [mailto:[EMAIL PROTECTED]] > Sent: Thursday, December 19, 2002 8:33 AM > To: Protel EDA Forum > Subject: Re: [PEDA] question about connectors and PCB manufacturers <snip> > One other consideration: is there enough space between the connectors to > actually put mating cables on them? Separating them by only a PCB thickness > (0.062 in.) doesn't seem like enough room for the hood/shell of both cables. > > > ----- Original Message ----- > From: "Anand Kulkarni" <[EMAIL PROTECTED]> > To: "Protel EDA Forum" <[EMAIL PROTECTED]> > Sent: Thursday, December 19, 2002 11:17 AM > Subject: [PEDA] question about connectors and PCB manufacturers > > > > Hi everybody, > > I have a question about the capability of PCB manufacturers. > > > > I have a surface mount SCSI connector with 68 pads . > > > > 050 inch x .100 inch Center - SCSI 3 Compatible - Shrouded > Straight - > Surface Mount Socket > > > > example : 2 identical connectors : > > _________________________________________ > > | _________________________ | > > | o / \ o | > > | --------------------------- | > > ----------------------------------------- > > Connector 1 > > > > _________________________________________ > > | _________________________ | > > | o / \ o | > > | --------------------------- | > > ----------------------------------------- > > > > Connector 2 > > > > > > Now this connector has got 2 holes , 1 on each end , apparently for > screwing to the board. > > > > Now, I want to place these connectors on opposite sides of > the board. > > i.e, one connector on the top surface and the other connector on the > bottom surface ; > > and I want them be perfectly aligned to each other , as > seen in the top > view. > > > > further ,I want to screw them "TOGETHER" through the board. > > i.e, nuts on both the top and bottom surface and the thread passing > through the vertically > > aligned holes. Again the holes have to be perfectly aligned. > > > > Also , the pads have to be prefectly aligned. > > > * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
