Thanks guys,
        for confirming it is not a singular isolated problem (based on
response only). It is an annoying little problem which limits the
effectiveness of using Mech layers 5 - 16. I had thought it was a code
problem because it was consistent across a number of machines, video cards
and had always been present since we switched to P99SE with only the new
mech layers being effected.

Anybody out there have any ideas to fix or root out the cause of this
problem?

Has anybody brought this up with Protel Tech support, what was their
response?

Brad Velander,
Lead PCB Designer,
Norsat International Inc.,
#300 - 4401 Still Creek Dr.,
Burnaby, B.C., V5C 6G9.
Tel. (604) 292-9089 direct
Fax (604) 292-9010
website www.norsat.com


> -----Original Message-----
> From: John Haddy [mailto:[EMAIL PROTECTED]]
> Sent: Thursday, September 13, 2001 3:04 PM
> To: Protel EDA Forum
> Subject: Re: [PEDA] Mechanikal Layers are disappearing
> 
> 
> I also have this problem - on multiple machines (IBM and HP) with
> different video cards and drivers.
> 
> I run Win2k with an S3 video card (32M) on the IBM; Win2k with an Elsa
> Gloria II video card (64M) on the HP
> 
> John Haddy

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to