I use the synchronizer (from sch to PCB) all the time with "update component footprints" checked, and it never puts back "the first footprint on the list". It respects whatever footprint is specified in each schematic symbol.
> -----Original Message----- > From: Bob Wolfe > Sent: Sunday, February 03, 2002 12:11 PM > > > John, > You should also point out that if you are going to use alternate footprints, > that if update footprints is needed to be used during synchronization to update > a bunch of updated or changed footprints in a board that the system will remove > any of these alternate footprints and put the first footprint on the list of footprints > in the symbol back on your board. This may or may not be a problem for you. > Bob > Robert M. Wolfe, C.I.D. > [EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
