> There are two ways to delete an object. One is to select it and the clear
> the selection.

Select and clear is the only reliable way to for me to delete an arc.


> >   Sometimes I can change properties
> >by setting a small snap grid and then double clicking around the arc 10 to 20
> >times.
>
> This is a clue. First of all, I suspect that the arc is large.

Arcs of all sizes have the same problem.


> It might also help if the arc is set to a wide line, but I don't know that this
> is really a factor.

I tried the large line width and it made no difference.

I guess I'll have to install SP6 now to see what it does.



* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
*  This message sent by: PROTEL EDA USERS MAILING LIST
*
*  Use the "reply" command in your email program to
*  respond to this message.
*
*  To unsubscribe from this mailing list use the form at
*  the Association web site. You will need to give the same
*  email address you originally used to subscribe (do not
*  give an alias unless it was used to subscribe).
*
*  Visit http://www.techservinc.com/protelusers/subscrib.html
*  to unsubscribe or to subscribe a new email address.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

______________________________________________________
To post a message: <mailto:[EMAIL PROTECTED]>

To unsubscribe or subscribe we recommend using the
form at our web site:
http://www.techservinc.com/protelusers/subscrib.html

You may also unsubscribe directly by email:
<mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum>
however this may fail if you're trying to unsubscribe
an "old" email address, an alias mail account, or if
your mail client uses an unusual encoding format.

To contact the Forum Administrator:
<mailto:[EMAIL PROTECTED]>

Reply via email to