i can assure you that our 'jumped' pad was in the cosmic ray category
and sounds just like brad's
i looked very carefully into what might have caused it and wound up
replacing the footprint with no good explanation
now that i recollect it, i *think* it did not respond to editing the XY
coords to fix the position
i think it kept jumping until i replaced the footprint
it was a 1mm pitch staggered dual row pattern (thru hole) and 1 of 20
pads jumped about 1/3 of the pitch in one axis
Dennis Saputelli
Abd ul-Rahman Lomax wrote:
>
> Since most of us have never seen a pad move as described, unless one of
> these possible causes rings a bell, we may not be able to identify the
> cause, *unless* the behavior can be reproduced. For all we know, it was a
> cosmic ray....
>
--
___________________________________________________________________________
www.integratedcontrolsinc.com Integrated Controls, Inc.
tel: 415-647-0480 2851 21st Street
fax: 415-647-3003 San Francisco, CA 94110
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
